Recessed lights for a 30 × 30 ft basement with a 11 ft ceiling
| Layoutacross the 30 ft dimension × along the 30 ft dimension | 5 × 5 |
|---|---|
| Spacing (rule of thumb)half of the 11 ft ceiling | 5.5ft |
| Actual spacing to mark outafter rounding to whole fixtures | 6 × 6ft |
| First light from the wallhalf a spacing — closer washes the wall, further leaves dark corners | 3 × 3ft |
| Room area | 900ft² |
| Target light levelfinished space with little daylight | 25fc |
| Total lumens needed | 22,500lm |
| Lumens per fixtureabout 12 W each in LED | 900lm |
- Room width
- 30 ft
- Room length
- 30 ft
- Ceiling height
- 11 ft
- Room
- basement
The grid
Spacing for recessed cans is ceiling height divided by two. A 11 ft ceiling gives 5.5 ft, which across a 30 × 30 ft room works out to a 5 × 5 grid — 25 lights.
Rounding to whole fixtures moves the real spacing to 6 × 6 ft. Mark the ceiling off those numbers, not off the rule of thumb. The first row sits 3 ft from the wall — half a spacing. Closer and you get a bright band down the wall; further and the corners go dark.
What to buy, not just how many
900 ft² at 25 footcandles needs 22,500 lumens in the room, which is 900 lumens per fixture — around 12 W in LED.
That is the number to shop by, and it is the one most layout calculators leave out. A 4″ LED downlight typically runs 600–800 lm; a 6″ runs 800–1,200 lm.
Before you cut
Find the joists first. A 5 × 5 grid rarely lands clear of framing on the first attempt, and shifting a can six inches to miss a joist is invisible once the trim is on. Put the whole layout on a dimmer while the wiring is open — it costs almost nothing then and cannot be added cheaply later.
Notes
- The spacing rule is ceiling height ÷ 2, which gives 5.5 ft here. Rounding to whole fixtures moves it to 6 × 6 ft — mark the ceiling off the real numbers, not the rule.
- 900 lumens per can is the figure to shop by. A 4″ LED downlight typically runs 600–800 lm and a 6″ runs 800–1,200 lm, so either size covers it.
- 25 fc is an ambient level, which is what you want here. Recessed lights alone make a room look flat; the fix is lamps and wall light, not more cans.
- Put them on a dimmer. It costs almost nothing at install, and it is the difference between a ceiling that works at dinner and one that works at 11pm.
- Check the joists before marking. A 5 × 5 grid rarely lands clear of framing on the first try, and moving a can 6 inches to miss a joist is invisible once the trim is on.
Nearby sizes
- Recessed lights for a 28 × 30 ft basement with a 11 ft ceiling
- Recessed lights for a 26 × 30 ft basement with a 11 ft ceiling
- Recessed lights for a 30 × 30 ft basement with a 10 ft ceiling
- Recessed lights for a 30 × 30 ft basement with a 12 ft ceiling
- Recessed lights for a 30 × 30 ft basement with a 9 ft ceiling
- Recessed lights for a 30 × 30 ft dining room with a 11 ft ceiling
- Recessed lights for a 30 × 30 ft garage with a 11 ft ceiling
- Recessed lights for a 30 × 30 ft home office with a 11 ft ceiling
Read more
- 2700K vs 3000K: A Difference You Only See Side by SideShown separately, almost nobody can tell 2700K from 3000K. Shown together, everybody can. That single fact decides how you should buy them.
- 3000K or 4000K in a Kitchen? Look at the Worktop, Not the ChartMost advice picks a number and defends it. The honest answer is that 3000K and 4000K are both correct, in different kitchens, and the deciding factor is what the light lands on.
- Vanity Lighting: Why the Fitting Position Beats the LumensA vanity is a face-lighting problem, not a room-lighting problem. Almost every bad bathroom light is a fitting in the wrong place rather than a fitting that is too dim.
- Bedroom Lumens: The Room Where Less Is the SpecificationThe bedroom is the only room where the target is a range you should deliberately sit at the bottom of, and where the dimmest setting matters more than the brightest.