Recessed lights for a 8 × 8 ft basement with a 10 ft ceiling
| Layoutacross the 8 ft dimension × along the 8 ft dimension | 2 × 2 |
|---|---|
| Spacing (rule of thumb)half of the 10 ft ceiling | 5ft |
| Actual spacing to mark outafter rounding to whole fixtures | 4 × 4ft |
| First light from the wallhalf a spacing — closer washes the wall, further leaves dark corners | 2 × 2ft |
| Room area | 64ft² |
| Target light levelfinished space with little daylight | 25fc |
| Total lumens needed | 1,600lm |
| Lumens per fixtureabout 5 W each in LED | 400lm |
- Room width
- 8 ft
- Room length
- 8 ft
- Ceiling height
- 10 ft
- Room
- basement
The grid
Spacing for recessed cans is ceiling height divided by two. A 10 ft ceiling gives 5 ft, which across a 8 × 8 ft room works out to a 2 × 2 grid — 4 lights.
Rounding to whole fixtures moves the real spacing to 4 × 4 ft. Mark the ceiling off those numbers, not off the rule of thumb. The first row sits 2 ft from the wall — half a spacing. Closer and you get a bright band down the wall; further and the corners go dark.
What to buy, not just how many
64 ft² at 25 footcandles needs 1,600 lumens in the room, which is 400 lumens per fixture — around 5 W in LED.
That is the number to shop by, and it is the one most layout calculators leave out. A 4″ LED downlight typically runs 600–800 lm; a 6″ runs 800–1,200 lm.
Before you cut
Find the joists first. A 2 × 2 grid rarely lands clear of framing on the first attempt, and shifting a can six inches to miss a joist is invisible once the trim is on. Put the whole layout on a dimmer while the wiring is open — it costs almost nothing then and cannot be added cheaply later.
Notes
- The spacing rule is ceiling height ÷ 2, which gives 5 ft here. Rounding to whole fixtures moves it to 4 × 4 ft — mark the ceiling off the real numbers, not the rule.
- 400 lumens per can is the figure to shop by. A 4″ LED downlight typically runs 600–800 lm and a 6″ runs 800–1,200 lm, so you could drop to 4″ cans or dim these down.
- 25 fc is an ambient level, which is what you want here. Recessed lights alone make a room look flat; the fix is lamps and wall light, not more cans.
- Put them on a dimmer. It costs almost nothing at install, and it is the difference between a ceiling that works at dinner and one that works at 11pm.
- Check the joists before marking. A 2 × 2 grid rarely lands clear of framing on the first try, and moving a can 6 inches to miss a joist is invisible once the trim is on.
Nearby sizes
- Recessed lights for a 8 × 10 ft basement with a 10 ft ceiling
- Recessed lights for a 8 × 12 ft basement with a 10 ft ceiling
- Recessed lights for a 8 × 8 ft basement with a 9 ft ceiling
- Recessed lights for a 8 × 8 ft basement with a 11 ft ceiling
- Recessed lights for a 8 × 8 ft basement with a 8 ft ceiling
- Recessed lights for a 8 × 8 ft basement with a 12 ft ceiling
- Recessed lights for a 8 × 8 ft dining room with a 10 ft ceiling
- Recessed lights for a 8 × 8 ft garage with a 10 ft ceiling
- Recessed lights for a 8 × 8 ft home office with a 10 ft ceiling
Read more
- 2700K vs 3000K: A Difference You Only See Side by SideShown separately, almost nobody can tell 2700K from 3000K. Shown together, everybody can. That single fact decides how you should buy them.
- 3000K or 4000K in a Kitchen? Look at the Worktop, Not the ChartMost advice picks a number and defends it. The honest answer is that 3000K and 4000K are both correct, in different kitchens, and the deciding factor is what the light lands on.
- Vanity Lighting: Why the Fitting Position Beats the LumensA vanity is a face-lighting problem, not a room-lighting problem. Almost every bad bathroom light is a fitting in the wrong place rather than a fitting that is too dim.
- Bedroom Lumens: The Room Where Less Is the SpecificationThe bedroom is the only room where the target is a range you should deliberately sit at the bottom of, and where the dimmest setting matters more than the brightest.